UEi EagleX Especificaciones descargar pdf (Pagina 5)

QUICK START GUIDE .

Turn Power on in area of

fresh air and allow to

countdown

Rotate test selector to Fuel.

Press

“s“UP or “t“DOWN

to scroll and select desired

fuel. Top line is selected fuel.

Rotate test selector to

“Flue T

est” and begin test

ing.

GETTING STARTED

WORKLIGHT AND DISPLAY

BASIC CO/COMBUSTION ANALYSIS

Press and Hold the “s“ UP

button to toggle between

fuel test screens 1 and 2.

Flue Test Pg.1: O2, CO, Draft

(P) and TF

Flue T

est Pg. 2: CO2, NO,

Efficiency and Excess Air.

(NO

upg

ade available on

Eag

le 2 and 2X.

comes standard on

Eagle 3 and 3X.)

Make any adjustments as

needed for pr

oper

combustion and wait for

analyzer to display any

change in the readings.

(repeat if necessary)

Once complete, remove

obe from the stack and

allow the analyzer to purge

in fresh air until CO sensor

readings return to ZERO

and O2 reads 20~21%

(20.9%). Continue to the

xt test or turn off your

analyzer if finished.

NOTE: print and store func-

tions may be used at an

point during testing

Connect flue probe

thermocouple connector to T1,

and connect flue probe to

water trap as shown above.

Use optional probe with T2 for

inlet temperature.

Insert Flue Probe in stack.

djust the cone so the end

of the probe is approximate-

ly. at the center of the stack

(4” stack adjust cone to

aprox 2” from end of

probe.)

GAS ZERO (EAGLEX SERIES ONLY)

Rotate test selector to Menu.

Make sure Analyzer is in

fresh air and press ENTER.

Analyzer will then Zero This

takes 90 seconds.

Press

“s“ UP Button to

GAS ZERO and press ENTER.

Re-Zero the analyzer in fresh air if needed for different fuel type or after large temperature rise.

NOTE: The Eagle X will automatically initiate Gas Zero if required for continued accurate results.

Best results are obtained at Steady State Efficiency (SSE). Allow equipment adequate warm-up time prior to testing.

After the Analyzer has

zeroed turn test selector to

ppropriate test screen.

ress

“s“U

P at any point to

turn on the backlit display

and worklight.

NOTE: backlight does not

work in the fuel menu.or

during purge.

NOTE: you will have to drill a hole at least 3/8”.

Use a high temp silicone to seal after testing.

QUICK START GUIDE .

1 2 3 4 5 6 7 8 9 10 ... 15 16

Comentarios a estos manuales

Sin comentarios

UEi EagleX Especificaciones Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para De medición, control y control UEi EagleX